While doing the installation, be careful in holding the components and follow the installation procedures. Connect the fan power cable from the mounted fan to the 3-pin fan power connector on the board. If the mainboard has a System Hardware Monitor chipset on-board, you must use a specially designed fan with speed sensor to take advantage of the CPU fan control. As the CPU is likely to move while the lever is being closed, always close the lever with your fingers pressing tightly on top of the CPU to make sure the CPU is properly and completely embedded into the socket. It supports a three-pin head connector. You can barely see the golden finger if the module is properly inserted in the socket. If you install two hard disks on cable, you must configure the second drive to Slave mode by setting its jumper.

Uploader: JoJotaur
Date Added: 13 September 2018
File Size: 64.60 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 19418
Price: Free* [*Free Regsitration Required]

Overheating Overheating will seriously damage the CPU and system, always make sure the cooling fan can work properly to protect the CPU from overheating. Press the CPU down firmly into the socket and close the lever.

Meanwhile, read the documentation for the expansion card to make any necessary hardware or software settings for the expansion card, such as jumpers, switches or BIOS configuration. You 7641 attach a serial mouse or other serial devices directly to the connector.

You can clear CMOS by shorting pin while the system is off. Position the heatsink onto the retention mechanism. Avoid clearing the CMOS while the system is on; it will damage the mainboard. Mic is a connector for microphones.

  ADAPTEC SCSI 29160N DRIVER DOWNLOAD

To connect to the ATX power supply, make sure the plug of the power supply is inserted in the proper orientation and the pins are aligned. Mount the fan on top of the heatsink.

Locate the CPU and its retention mechanism on the motherboard. When adding or removing expansion cards, make sure that you unplug the power supply first. Before inserting the power supply connector, jsi make sure that all components are installed properly to ensure that no damage will be caused.

The gold arrow should point towards the lever pivot.

When you 6471 installing the CPU, make sure the CPU has a heat sink and a cooling fan attached on the top to prevent overheating. While doing the installation, be careful in holding the components and follow the installation procedures.

Then push it in until the golden finger on the memory module is deeply inserted in the socket. Follow 67741 instructions below to clear the data: As the CPU is likely to move while the lever is being closed, always close the lever with your fingers pressing tightly on top of the CPU to make sure the CPU is properly and completely embedded into the socket.

It supports a three-pin head connector. The plastic clip at each side of the DIMM slot will automatically close. Memory modules can be installed in any combination as follows: Also, it provides the instructions on connecting the peripheral devices, such as the mouse, keyboard, etc. If the mainboard has a System Hardware Monitor chipset on-board, you must use a specially designed fan with speed sensor to take advantage of the CPU fan control.

  DSC 2770 VISTA DRIVER

MS MOTHERBOARD | Emachines MS K8T Motherboard

Then return to pin position. J9 Optional You can connect a joystick or game pad to this connector. IDE1 can connect a Master and a Slave drive. Floppy Disk Drive Connector: The third PCI slot supports 2 master devices.

MSI MS-6741 Manuals

It’s a community-based project which helps to repair anything. Getting Started Chapter 1. Look for the gold arrow. You must configure second hard drive to Slave mode by setting the jumper accordingly. Connect the fan power cable from the mounted fan to the 3-pin fan power connector on the board. Then push down the power supply firmly into the connector. Press the two levers down to fasten Press down the fan until its four clips get wedged in the holes of the retention mechanism.

Otherwise, the Line-Out connector on the back panel will not function.